1" Carbide Cutting / Shaping Wheel

Cut, Shape & Finish all with 1 tool!

CW1 - Carbide Cutting / Shaping Wheel.  1” (25mm)

FEATURES & BENEFITS:

1" carbide cutting/shaping wheel for DIY, modeling and smaller work pieces in tight spaces.

• Cuts, shapes & finishes in one operation.
• Carbide grit on the edge and both faces. Can be ‘pushed and pulled’ to create pockets and hollows.
• ‘Stroke’ bevels and create hollows, using the face of the wheel.
• Effortless cuts. Smooth sanded finishes.
• Minimal to no chipping on finished surfaces, such as fiberglass and/or melamine
• Very strong. Won't bend or shatter.
• Grit won't tear loose.
• Mounted on an extra strong, steel mandrel (ESM)

MATERIALS:

Cuts, carves and sands swiftly and cleanly on the following materials:

• Hard and soft woods
• MDF, Oak & Pine molding
• Fiberglass
• Composites
• Carbon Fibre
• Laminates
• ABS plumbing
• Rigid and flex PVC piping
• Rubber hose
• Plastic garden hose
• Engineered wood floor (up to 3/8” thick)
• Laminate ‘click’ floor
• Gourds
• and more!
• (not recommended for use on metals)

SUGGESTED APPLICATIONS:

Extraordinary model making & craft cut-off and shaping tool...

• Cut-off smaller planks and dowels and work in tight spaces
• 'Push / pull / grind' and create 'pockets & cavities' for RC aircraft nose cones, fuselages, ship hulls, gourds etc
• Create wiring and control rod slots in RC aircraft wings
• Trim RC car plastic bodies and carbon fibre rods
• Make decorative slots in wood cabinets, boxes, gourds etc.
• Trim wood/fibreglass/plastic/carbon-fibre and composites etc., up to 3/8” thick
• and much more...

To assist you with your selection of the appropriate grit grade for your DuraGRIT® carbide sanding tool, note some typical uses based on grit grades by reading the following knowledge base article:

What are Typical Uses (and suggested grit grades) for DuraGRIT Carbide Tools?
https://help.duragrit.com/article/21-what-are-typical-uses-for-duragrit-carbide-tools

Diameter: 1" (25mm)
Grit Grades: 80 grit or 120 grit
Depth of Cut: 3/8” (9mm)
Kerf: 80 grit: 0.08” (2.00 mm), 120 grit: 0.059” (1.51 mm)
Extra Strength Mandrel: 1/8" (3mm)

KERFS for various DuraGRIT Cutting Wheels (width of groove):

• SR-CW1-080: 0.08” (2.00 mm)
• SR-CW1-120: 0.059” (1.51 mm)
• SR-CS4-060: 0.064” (1.62 mm)
• SR-CW5-060: 0.060” (1.53 mm)

(Kerf widths are approximate and will vary according to density and grain of the material being cut)