3/8" Ball End Carbide Burr

Carbide Ball End Carving Burr

BE3 - Ball End Carbide Carving Burr - 3/8” (9mm)

3/8" steel, spherical ball coated in carbide and available in 60 & 80 grit.
1/8" extra strength steel mandrel.

This great tool is terrific for dimpling and channelling.

This long life carbide coated burr is designed primarily for wood and gourd carving. In addition to being an amazing carving burr, it can be used in DIY and modelling functions. The tip is removable and can be cleaned to further extend its already long working life!  At the same time as removing and shaping material, this tool smooths to a sanded finish, dictated by the grit grade!

FEATURES & BENEFITS:

• Create dimples and hollows
• Smooth 60 or 80 grit sanded finishes.
• Very strong.
• Grit won’t tear loose.
• Mounted on an extra strong, steel mandrel (ESM)
• Can be cleaned and restored to ‘as new’ condition for the next project.

MATERIALS:

Carve and dimple on the following materials:

• Hard and soft woods
• Composites
• Fiberglass
• Rigid Foam
• Gourds
• and more!
• (Not recommended for use on metal)

To assist you with your selection of the appropriate grit grade for your DuraGRIT® carbide sanding tool, note some typical uses based on grit grades by reading the following knowledge base article:

What are Typical Uses (and suggested grit grades) for DuraGRIT Carbide Tools?
https://help.duragrit.com/article/21-what-are-typical-uses-for-duragrit-carbide-tools

Diameter: 3/8” (9mm)
Extra Strength Mandrel: 1/8" (3mm)
Grit Grades: Available in 60 and 80 grit

(SR-BE3 3/8" Ball End Burr was previously known as the SR-SP4 3/8" Sphere Burr)